CAN, 18F2680 & Flowcode 3
Posted: Mon Mar 09, 2009 5:43 pm
Hi,
I am having trouble getting the CAN interface to work i.e. when any CAN module is loaded ( load buffer etc.) the main program halts / freezes
I have looked back on forums and found CAN related problems but I assumed these had been debugged as I am using v3.4.7.48 flowcode.
I am new to using forums so please excuse me, as I am not sure how much data to put in this letter
Thanks
Rob
I am having trouble getting the CAN interface to work i.e. when any CAN module is loaded ( load buffer etc.) the main program halts / freezes
I have looked back on forums and found CAN related problems but I assumed these had been debugged as I am using v3.4.7.48 flowcode.
I am new to using forums so please excuse me, as I am not sure how much data to put in this letter
Thanks
Rob