Question about dsPIC33

For users of Matrix Multimedia Electronics software to discuss projects, circuits and any other electronics concepts.

Moderators: Benj, Mods

Post Reply
RLOPES780
Posts: 119
Joined: Tue Apr 07, 2015 11:01 am
Been thanked: 3 times
Contact:

Question about dsPIC33

Post by RLOPES780 »

I will use dsPIC33.
The supply voltage is 3.6 volts.
I will use a interfade with pins I / O (RBO, RB1, etc) with an LCD display generic.
Supply voltage of the LCD display is 5 volts.
I can directly on the pins of dsPIC33 with pins the display?

kersing
Valued Contributor
Valued Contributor
Posts: 2045
Joined: Wed Aug 27, 2008 10:31 pm
Location: Netherlands
Has thanked: 553 times
Been thanked: 1081 times
Contact:

Re: Question about dsPIC33

Post by kersing »

1) Please do not use all capitals in your messages. I do not like people yelling so I lowercased your message.

2) dsPIC33 devices use a supply voltage of 3.3 volt, not 3.6 volt.

3) The answer to your question is: depends. Most dsPIC33 have a couple of 5 volt tolerant input pins. However for a display you need output and the high level of the pins (at roughly 3.3 volt) might not high for you display. You will need to look at the data sheet for your display to determine what the level for a 1 input signal is.
“Integrity is doing the right thing, even when no one is watching.”

― C.S. Lewis

Post Reply