When I try to simulate with debugger enabled I get message "Could not communicate with ICD"
J2 on ICD is labeled the same as the connections for the PICKIT2 Is this correct?
So i plugged the pickit2 into the USB out jack just need to move cable from pickit2 to ICD and change switch position back and forth?
But it doesn't work any suggestions?
ICD Connections same as pickit2? Not communicating
-
markus747
- Posts: 33
- Joined: Mon Jul 23, 2012 7:17 pm
- Location: Petaluma california USA
- Has thanked: 26 times
- Been thanked: 2 times
- Contact:
ICD Connections same as pickit2? Not communicating
- Attachments
-
- 2013-02-14 09.22.26.jpg (97.09 KiB) Viewed 4493 times