Hi Team.
Can you please help me ,is there anyway that I can link the MCP2515 CAN controller INT pin to one of the IOC pins on the Micro ,
in a busy application polling the CAN bus results in a loss of messages,
I am prepared to do the HW change myself but with out a schematic it is Risky affair
MIAC CAN Interrupt
- QMESAR
- Valued Contributor
- Posts: 1287
- Joined: Sun Oct 05, 2014 3:20 pm
- Location: Russia
- Has thanked: 384 times
- Been thanked: 614 times
- Contact:
Re: MIAC CAN Interrupt
Hi Leigh,
Sorry it is MIAC dsPIC V3 or something
Sorry it is MIAC dsPIC V3 or something
https://www.flowcodexchange.com/
Regards QMESAR
Regards QMESAR
- LeighM
- Matrix Staff
- Posts: 2178
- Joined: Tue Jan 17, 2012 10:07 am
- Has thanked: 481 times
- Been thanked: 699 times
- Contact:
Re: MIAC CAN Interrupt
There are no spare inputs.
But you could link across to either (UART0 RX) Port E1, or (UART1 RX) Port E3
Assuming you don't require both UARTs
These are available if you remove the UART selection header link ...
But you could link across to either (UART0 RX) Port E1, or (UART1 RX) Port E3
Assuming you don't require both UARTs
These are available if you remove the UART selection header link ...
- QMESAR
- Valued Contributor
- Posts: 1287
- Joined: Sun Oct 05, 2014 3:20 pm
- Location: Russia
- Has thanked: 384 times
- Been thanked: 614 times
- Contact:
Re: MIAC CAN Interrupt
Leigh
Thank you that helps a lot ,I do not need both UARTS only 1 for the RS485 ,
Thanks again
Thank you that helps a lot ,I do not need both UARTS only 1 for the RS485 ,
Thanks again
https://www.flowcodexchange.com/
Regards QMESAR
Regards QMESAR