Page 1 of 1
dsPIC MIAC RS485 Communication
Posted: Wed Dec 30, 2020 11:58 am
by QMESAR
Hi Team,
Can you please advise me on using the dsPIC MIAC RS485 should I add the 120 Ohm terminator resistor or is this already included in the Hardware.
I did not find any reference in the manual regrading the terminators
Appreciate your input
Re: dsPIC MIAC RS485 Communication
Posted: Wed Dec 30, 2020 12:07 pm
by LeighM
Hi,
No, there is no internal termination resistor.
Or pullup/pulldown
Regards
Leigh
Re: dsPIC MIAC RS485 Communication
Posted: Wed Dec 30, 2020 12:50 pm
by QMESAR
Hi
Thanks Leigh
Re: dsPIC MIAC RS485 Communication
Posted: Wed Dec 30, 2020 1:35 pm
by QMESAR
Hi Leigh
Can you also tell me please if there is TVS diodes on the front end of the Transceiver node to protect the transceiver ,as this MIAC will run in an noisy environment.
Thanks a million
Re: dsPIC MIAC RS485 Communication
Posted: Wed Dec 30, 2020 5:26 pm
by LeighM
The transceiver is a SN65HVD10DR which has built in ESD Protection,
but external extra TVS sounds like a good idea in your application
Re: dsPIC MIAC RS485 Communication
Posted: Wed Dec 30, 2020 6:11 pm
by QMESAR
Leigh
Thanks now I know how to layout the wiring and connections the internal ESD TVS is not enough for sure