Hi,
can anybody help me ? Dont know if i have posted this in the right place sorry if not
i am trying to set up my flow code with my experimenter board and programmer.
programmer is a microchip pikkit 2
experimenter board is NX-877 Plus II from Microcontrollershop.com
i am getting errors ( see attaches screen shots)
pic of config error i saved as a hex file then opened the programmer software then imported to try and write to chip
can anybody advise as to what is wrong and how to sort it
regards
steve
Help required configuring Flowcode
- Steve001
- Valued Contributor
- Posts: 1189
- Joined: Wed Dec 31, 2008 3:37 pm
- Has thanked: 460 times
- Been thanked: 523 times
- Contact:
Help required configuring Flowcode
- Attachments
-
- Compiler error 1.JPG (26.03 KiB) Viewed 3408 times
-
- Compiler setup.JPG (52.67 KiB) Viewed 3406 times
-
- config error.JPG (101.5 KiB) Viewed 3407 times
Success always occurs in private and failure in full view.
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: Help required configuring Flowcode
Hello
I think that the problems is that you have to manually include the configuration data. Please see the attached document for details of how to do this.
I think that the problems is that you have to manually include the configuration data. Please see the attached document for details of how to do this.
- Attachments
-
- 1. Flowcode with Microchip Dev Tools.ppt
- (939.98 KiB) Downloaded 334 times
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel