Flowcode Newbie Questions.
Posted: Sun Oct 10, 2010 9:17 am
Being new to Flowcode I have some newbie questions.
1) I see in Chip you can set the oscillator to XTAL, but how does Flowcode know what crystal you have attached?
2) I notice that some components add C code that may not get called. Is the complier clever enough to eliminate code that is never called.
3) If I want to output a waveform on Pin X of Port Y i.e. timing critical. Do I have to allow any time for the Output function? Or can I just use the delays between Outputs without worrying that the Output takes a small delta of time.
Thanks Keith
1) I see in Chip you can set the oscillator to XTAL, but how does Flowcode know what crystal you have attached?
2) I notice that some components add C code that may not get called. Is the complier clever enough to eliminate code that is never called.
3) If I want to output a waveform on Pin X of Port Y i.e. timing critical. Do I have to allow any time for the Output function? Or can I just use the delays between Outputs without worrying that the Output takes a small delta of time.
Thanks Keith