downloading to pic
Posted: Mon Sep 27, 2010 8:51 am
Hi All, I have written a flowcode program which works perfectly, however, when I compile to hex and use the hex file in MPlab i get runnung screens of errors, mainly about bank bits etc. and finally a build successful msg. I have configured the chip to use the internal oscillator. When I put the pic into the hardware nothing happens. I think that I have fouled up the chip config. When the program starts it should output pulses to port A2 until it sees a switch then waits for input. I am using a pic 16F886 and can find no header file (16F886.inc) in mplab, is this a problem? Also there is no oscon config info in the asm file so I am assuming that my osc settings are suspect? I am using FC ver 4.