I have a two EB006-9 board and some other boards (two EB006-8 and one EB006-6 boards).
The older boards all work, but the EB006-9 boards do not.
One board get recognized by the mLoader 4.0.0.1 and the other does not get recognized at all.
On both boards, the Power LED is on. all other LED's are off.
(I got hold of these boards some time ago, they unfortunately came without the Flowcode license, but my interest in the boards has re-kindled )
I have found the reflash instructions for the EB006-9 boards an d followed it. but no avail... (Using MPLAB 8.92)
Both board get detected by MPLAB:
Target Detected
Device ID Revision = 00004002
But when flashing the chips I get:
Programming failed.
Is there something else that I can try, other than putting new chips on the board?
Reflashing EB006-9
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: Reflashing EB006-9
Hello,
Using MPLAB and I guess a PICkit are you programming using the ICSP header? This connects to the slave chip e.g. the 16F1937 device and not the host chip.
The host chip has a hidden ICSP header located here.
Using MPLAB and I guess a PICkit are you programming using the ICSP header? This connects to the slave chip e.g. the 16F1937 device and not the host chip.
The host chip has a hidden ICSP header located here.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel