Reflashing EB006-9

For E-blocks user to discuss using E-blocks and programming for them.

Moderators: Benj, Mods

Post Reply
Copeland
Posts: 1
Joined: Mon Apr 27, 2020 10:49 am
Contact:

Reflashing EB006-9

Post by Copeland »

I have a two EB006-9 board and some other boards (two EB006-8 and one EB006-6 boards).
The older boards all work, but the EB006-9 boards do not.
One board get recognized by the mLoader 4.0.0.1 and the other does not get recognized at all.
On both boards, the Power LED is on. all other LED's are off.
(I got hold of these boards some time ago, they unfortunately came without the Flowcode license, but my interest in the boards has re-kindled :-) )

I have found the reflash instructions for the EB006-9 boards an d followed it. but no avail... (Using MPLAB 8.92)
Both board get detected by MPLAB:
Target Detected
Device ID Revision = 00004002
But when flashing the chips I get:
Programming failed.

Is there something else that I can try, other than putting new chips on the board?

User avatar
Benj
Matrix Staff
Posts: 15312
Joined: Mon Oct 16, 2006 10:48 am
Location: Matrix TS Ltd
Has thanked: 4803 times
Been thanked: 4314 times
Contact:

Re: Reflashing EB006-9

Post by Benj »

Hello,

Using MPLAB and I guess a PICkit are you programming using the ICSP header? This connects to the slave chip e.g. the 16F1937 device and not the host chip.

The host chip has a hidden ICSP header located here.
SS1.jpg
SS1.jpg (215.73 KiB) Viewed 3355 times

Post Reply