Hi
I just received my programmer board and tested it, all works fine. However my flowcode 4 for pic24 was setup to use the pickit3. I tried to change this but no joy. I get the following message:
Error returned from [pic30-gcc.exe]
Return code = 1
Flowcode was unable to compile the flowchart's C code due to the following errors:
If your flowchart contains C code, please review this carefully. If your flowchart contains no C-code or you have thoroughly reviewed the code, contact Technical Support.
FINISHED
EB064 for dspic24
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: EB064 for dspic24
Hello,
If you go to The Chip -> Compiler Option menu then you could try hitting the restore defaults button.
If this fails then the settings should look similar to this, depending on your file path to Flowcode.
Compiler Location -> C:\Program Files\Matrix Multimedia\Flowcode PIC24&dsPIC V4\Tools\MX_bats\pic16_C30_comp.bat
Compiler Parameters -> "%f" "%D" %T
Linker Location -> C:\Program Files\Matrix Multimedia\Flowcode PIC24&dsPIC V4\Tools\MX_bats\pic16_C30_link.bat
Linker Parameters -> "%f" %T %y
mLoader Settings
Programmer Location -> C:\Program Files\Matrix Multimedia\Flowcode PIC24&dsPIC V4\tools\mLoader\mLoaderv3.exe
Programmer Parameters -> -config -chip %p "%f.hex"
Use External Programmer - Ticked
Location -> C:\Program Files\Matrix Multimedia\Flowcode PIC24&dsPIC V4\Tools\PPP\PPPv3.exe
Parameters -> -chip %a -config
Hope this helps.
If you go to The Chip -> Compiler Option menu then you could try hitting the restore defaults button.
If this fails then the settings should look similar to this, depending on your file path to Flowcode.
Compiler Location -> C:\Program Files\Matrix Multimedia\Flowcode PIC24&dsPIC V4\Tools\MX_bats\pic16_C30_comp.bat
Compiler Parameters -> "%f" "%D" %T
Linker Location -> C:\Program Files\Matrix Multimedia\Flowcode PIC24&dsPIC V4\Tools\MX_bats\pic16_C30_link.bat
Linker Parameters -> "%f" %T %y
mLoader Settings
Programmer Location -> C:\Program Files\Matrix Multimedia\Flowcode PIC24&dsPIC V4\tools\mLoader\mLoaderv3.exe
Programmer Parameters -> -config -chip %p "%f.hex"
Use External Programmer - Ticked
Location -> C:\Program Files\Matrix Multimedia\Flowcode PIC24&dsPIC V4\Tools\PPP\PPPv3.exe
Parameters -> -chip %a -config
Hope this helps.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel