Flashing EEPROM with old EBLOCKS EB-006-6

For E-blocks user to discuss using E-blocks and programming for them.

Moderators: Benj, Mods

Post Reply
cellomar
Posts: 2
Joined: Tue Mar 09, 2021 9:23 pm
Contact:

Flashing EEPROM with old EBLOCKS EB-006-6

Post by cellomar »

I found my father's old Eblocks multiprogrammer in my garage and I'm wondering if I can use it to flash an 8 pin eeprom i took off a pc motherboard. Its a winbond 25Q64FVAIG.

Long story short I the mobo somehow has an incorrect BIOS flashed and after exhausting all my options, I've concluded that I need an eeprom programmer to flash the chip, and I'm hoping I can manage with this eblocks board instead of buying a programmer just for one flash.

I have bit of exp with embedded programming but Im a noob really, any help would be sincerely appreciated. So far I've got the drivers installed and I have mloader installed as well. When I try to autodetect the chip I get "unable to communicate with target".

The data I'm trying to flash onto the chip is a file with the .bss extension. Is this possible or should I bite the bullet and just buy a dedicated programmer?

kersing
Valued Contributor
Valued Contributor
Posts: 2045
Joined: Wed Aug 27, 2008 10:31 pm
Location: Netherlands
Has thanked: 553 times
Been thanked: 1081 times
Contact:

Re: Flashing EEPROM with old EBLOCKS EB-006-6

Post by kersing »

Sorry to disappoint but the EB006 is for programming (certain) PIC controllers.
“Integrity is doing the right thing, even when no one is watching.”

― C.S. Lewis

cellomar
Posts: 2
Joined: Tue Mar 09, 2021 9:23 pm
Contact:

Re: Flashing EEPROM with old EBLOCKS EB-006-6

Post by cellomar »

ty

Post Reply