Matrix user forums

Hello! Will work with flowcode processor ARM? or better go to the AVR or PIC?

Tried on windows 7 32-bit, still does not work ((((((

Thomas Thor, thanks for the tip!
Tomorrow, if I can, I will try to windows 7 32-bit.

Firmware that works only gives this message. Firmware in .*bin (by the way, I also tried to download and .*bin .*heh)

archive directly firmware and source code

What else can be done? Or is useless?

Hi, Benj !!!

I tried all three options. With either LED flashes do not, unfortunately. What options are there to solve the problem yet?

Thanks for the answer! Yes, I want to use the code directly on the device. I did everything according to your instructions. I replaced AT91SAM7S256-ROM.dl from your archive, but the LED and did not blink! I was upset. Then I decided to compare the file that I had and you gave me. They are completely...

What possible reason that the program is not blinking LED?

Thank you for your help. Last hope for you :) Yes, the jumpers stands. Here's the code: //************************************************************************************ //** //** Source name: D:\test\test.fcfx //** Title: //** Description: //** Device: ARM.AT91SAM7S.AT91SAM7S256 //** //** Gene...

Hello. Using FlowCode can program the controller or not? Does anyone do that? Sad that bought development board, and nothing can be done.

help me, please

Benj, thank you very much for your help in getting acquainted with flowcode. I installed the patch 6.0.4 as you advised. But still I do not blink LEDs. 1.png Port P24 I can not see because it is used in the circuit and is not separately displayed. This datasheet on SAM7-P256: SAM7-Pxxx.pdf Could you...

Can anybody help me with this problem?

What else could be the problem?

Although, I tried to download the firmware obviously working through SEGGER - everything works, the LEDs flash.
So, the problem in FlowCode. Just what the problem - I do not know.

Thanks for your help, Martin! LED is off. I tried to port fed only "true", but it did not help. LED does not light. I changed the program on your screenshot, but still does not work. Perhaps I am wrong somehow sews. Please look at the screens where I sews chip. Maybe you can tell me what I mistake. ...

I bought on the development board AT91SAM7S256, Decided LED blinked. Actually, that's a piece of circuit evaluation board (ports with LEDs) http://s43.radikal.ru/i101/1403/88/206093232b2b.png here's a program written in flowcode http://s020.radikal.ru/i723/1403/e3/b9a6a0d972d7.png compiling reports:...