Looking for KS0108 custom code to allow GLCD to work. Only got 4 pins to assign ports too in flowcode component.
Need CS1,CS2,RS,RW,E,RST,DATA0-7.
Any pointers helpful.
Search found 5 matches
- Fri Apr 17, 2015 4:32 pm
- Forum: Flowcode V5 Free Edition
- Topic: GLCD KS0108 CUSTOM_CODE
- Replies: 1
- Views: 6212
- Tue Apr 16, 2013 5:26 pm
- Forum: Flowcode V5 Free Edition
- Topic: flowcode and mikroProg
- Replies: 6
- Views: 4177
Re: flowcode and mikroProg
Thanx Dazz, once again for your knowledge and advice much appreciated.
- Mon Apr 15, 2013 10:11 pm
- Forum: Flowcode V5 Free Edition
- Topic: flowcode and mikroProg
- Replies: 6
- Views: 4177
Re: flowcode and mikroProg
Again thanks for the info Dazz I suppose your right about the safety net! Have you had any problems with the 7-seg when writing out from flowcode?
- Sun Apr 14, 2013 1:52 pm
- Forum: Flowcode V5 Free Edition
- Topic: flowcode and mikroProg
- Replies: 6
- Views: 4177
Re: flowcode and mikroProg
Thanx Dazz for the info did what you said and seemed to work, guess it wont go straight in and program? Is there any settings in flowcodes configure chip to make the mikroProg pickup and therefore not have to set up the configuration.
- Sun Apr 14, 2013 8:39 am
- Forum: Flowcode V5 Free Edition
- Topic: flowcode and mikroProg
- Replies: 6
- Views: 4177
flowcode and mikroProg
is it possible to use mikroProg programmer with flowcode and what would be the configuration?
any pointers would be helpful. Have a configuration for pickit 2 but interested in easyPIC v7.
any pointers would be helpful. Have a configuration for pickit 2 but interested in easyPIC v7.