Thank you for your reply.
I suppose any time should be ok.
I mean that if someone can send me the code i will adjust it to work from a time perspective.
This signal will go to a router.
I can test and le you guys know, i think it is easier.
Search found 32 matches
- Thu Nov 15, 2012 2:56 pm
- Forum: Flowcode V5
- Topic: Sending a break signal using 16F877 usart
- Replies: 21
- Views: 12659
- Thu Nov 15, 2012 12:43 pm
- Forum: Flowcode V5
- Topic: Sending a break signal using 16F877 usart
- Replies: 21
- Views: 12659
Re: Sending a break signal using 16F877 usart
I contacted the author of PuTTY and he replied to me with this... > Could you please explain to me what happens when someone sends the > break key command (Alt+B) and is connected to a device through > serial port? It causes a pattern of voltages on the serial wire which is different from any patter...
- Thu Nov 15, 2012 10:20 am
- Forum: Flowcode V5 Suggestions
- Topic: Simulation completed window
- Replies: 5
- Views: 8343
Re: Simulation completed window
Thank you DavidA!!!
btw when will 6 be on air?
btw when will 6 be on air?
- Thu Nov 15, 2012 9:22 am
- Forum: Flowcode V5
- Topic: Sending a break signal using 16F877 usart
- Replies: 21
- Views: 12659
Re: Sending a break signal using 16F877 usart
I have tried with the code attached but the break signal is not detected...
- Thu Nov 15, 2012 9:13 am
- Forum: Flowcode V5
- Topic: Sending a break signal using 16F877 usart
- Replies: 21
- Views: 12659
Re: Sending a break signal using 16F877 usart
Thank you for your reply but this is not the case... if you see http://www.freebsd.org/doc/en/articles/serial-uart/index.html it mentions... 1.4.2 RS232-C Break Signal RS232-C also specifies a signal called a Break, which is caused by sending continuous Spacing values (no Start or Stop bits). When t...
- Thu Nov 15, 2012 7:45 am
- Forum: Flowcode V5
- Topic: Sending a break signal using 16F877 usart
- Replies: 21
- Views: 12659
Sending a break signal using 16F877 usart
Hello everyone! I am trying to generate a break signal using 16F877's usart. Actually the same break signal that e.g putty terminal software generates. I know it is not a character but a line condition. I have read about it but i am not sure how to create it. Any help would be appreciated. Thank you...
- Thu Nov 15, 2012 7:40 am
- Forum: Flowcode V5 Suggestions
- Topic: Simulation completed window
- Replies: 5
- Views: 8343
Simulation completed window
Hello everyone!
Would it be possible to add an option in the preferences so as not to have the simulation completed litle window show up?
Instead show it on the status bar of the software?, when checked?
Would it be possible to add an option in the preferences so as not to have the simulation completed litle window show up?
Instead show it on the status bar of the software?, when checked?