Matrix user forums

Hello Benji, Thanks for the link. Although the message claimed this was SAM-BA 2.83, the screen presentation was marked SAM-BA 2.7. That said, I went on to remove driver listed in the USB section of the Device Manager. Once the USB driver was removed I went on to install the new driver, that ID’d it...

Hello Again Dave, No luck with the website. I couldn’t identify anything I could recognize. I did down load the Technical Datasheet for the ARM Programmer & Daughter Board; But understand some instructions need to be updated for the EB185 to operate correctly with Windows 7.

Hi! David, I'm trying to get the EB185 run on Windows 7 ( 32 bit ) but have had no success. I was told I needed SAM-BA v2.8 but I have been unable to locate a copy. Most of my confusion arises out of old imformation, and old drivers. I could really use the latest copy of insturctions on how to re-fl...

I am using the C4ARMs

With EX 1 loaded, the build process works fine, it compiles with no errors and ends the process with Exit Code: 0. As soon the Program Device is started I get the instruction to Connect the device to USB Port & enter programming mode by holding ‘Prog’ button & tapping the ‘Reset” button. Before I ca...